Only thing left on my grand lizard is the 3 bank flasher doesn’t work. I changed bulb , checked the small board for loose wires.
It looks intact. There are two resistors on it can a bad resistor cause it not to work?
You're currently viewing posts by Pinsider topkat.
Click here to go back to viewing the entire thread.
Only thing left on my grand lizard is the 3 bank flasher doesn’t work. I changed bulb , checked the small board for loose wires.
It looks intact. There are two resistors on it can a bad resistor cause it not to work?
Quoted from onemoresean:Check for continuity on the orange wire, the solder doesn't look too good.
Will check that too..ty
My thinking is the orange and red are power and the white purple is the cpu control ?
Does the resistor on the board control both of the flashers in the photo? that are tied in with the yellow?
And thanks. I will use that to test them
I think I tried new bulbs in both.. but will make sure. I will check the resistor and the solder joint as well
Thanks. Even I can’t mess that up
Do I need to be in the test mode, testing that flasher to Do that or just with power on?
Ok. So both bulbs
Light when I jumped red to green. They also light green to yellow.
Does that point to a tip on the board. ?
Now it’s working. I don’t get it must be one of the solder joints as pointed out as well. All I did was move things
Quoted from GRUMPY:Could be the big resistor is cracked internally. Started working again after moving it around, but it will stop working again after a while.
I ordered new resistors. Will replace to be safe. Thanks
You're currently viewing posts by Pinsider topkat.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/can-a-bad-warming-resistor-short-flasher-?tu=topkat and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.