This was a machine that I listed and sold a month or so ago at 1100.

This was a machine that I listed and sold a month or so ago at 1100. Ed cleaned it up a little and installed a proper drop target and replaced some rubber. I guess HH is not his cup of tea.

I picked up the getaway and there was quite a bit wrong with it. The DMD driver board had to be repaired, HV section. It also had a switch matrix issue from battery leakage that I fixed. Also, it had a 5 volt issue reset issue that had to be addressed. While it looked like a great deal from a distance, it was just OK. The good news is that it is up and running and it is not going to be parted out.

We talked about it. In the end, he was looking for too much money for it. I told him to give me a call when he needs to move it.

Does anyone want a Getaway that is fully working and just needs to be shopped out. The Dome is inside the cabinet, but the motor is not present. You can have it at my cost:

Purchase $1275
Pickup $100
New Rottendog Driver Board $300
New DMD Driver Board $90
MPU Repair $50
Total $1815

I can also sell the machine with the original boards at $1375. Let me know by 11/19 otherwise I will start shopping it out.

Sean

DSC06094.JPG

DSC06095.JPG

DSC06096.JPG

DSC06097.JPG

DSC06098.JPG

DSC06099.JPG

Sale pending on the Getaway.

Sean

Getaway sold, thanks for the interest. Good buyer alert goes out to Joe (Acejedi).

Sean

Looks like John Telner in Oakland got it.