Hello,
I have a Cactus Canyon that I did a minor shop job (rubbers, clean playfield...). I took all the parts off and put them all back. Although I am lacking in repair experience, I have done this with over 15 working tables so far with little to no problems.
When I turned on the table after reassembling it, I got a "Check fuses F101 and F106, J127 and 12v opto power".
All fuses are good (this includes F109). The LED100 light (12v reg) was out. When I unplugged the power output from the power board (J101) the light would come back on.
I am lucky that I have a lot of tables here, so I swapped the power board from a No Good Gofers and the 12v led problem DID transfer to the No Good Gofers so I figured I was home free. When I put the No Good Gofers Board into the Cactus Canyon, the 12v light now lights up just fine but I am still getting the same error. I have no power (no led) to the main opto board and all my optos on the table are out (optos are normally closed, right?).
I have not checked the voltages at the TPs yet. I will get to that tomorrow.
I am hoping someone can give me some diagnostic ideas. Should I disconnect the opto board? If I do, do I pull all four connectors off or just two. Will That tell me something? Can someone tell me which connector from the power board supplies the power to the opto board?
Anything will help me. Thanks in advance.