Thanks for another great guide Vid! Here's what I have to work with. This baby soaked up some water for sure. Looks like it swelled a good bit. Debating if I should try to repair the back or just replace? Figure if I replace the back I'll slide the bottom board out and replace it also. As much as I was hoping to avoid it, I'll most likely end up sanding it all down and getting a set of stencils to redo the whole cab and head.
20190427_203233 (resized).jpgP5032479 (resized).JPGP5032480 (resized).JPGP5032559 (resized).JPGP5032562 (resized).JPG
Same debate on the "neck" fill and glue or cut new? The top is planking from getting wet too and I would like to get that smoothed out.
P5032475 (resized).JPGP5032476 (resized).JPGP5032558 (resized).JPG