Ik zou graag ook een exemplaar willen voor de nieuwe plastic set

Consider putting the design on Thingiverse. Where did you get the decals?
Would it be possibly to print the decals into the plastic with a multicolor printer?

Hi all,
Here's some pics and my opinion on this mod. I received both the original fit and the repro fit earlier this week.
TL;DR; Huge improvement over the original. Recommended!

1 (resized).jpg

In my opinion it looks very good, like it should have been in the first place. This mod is easy to install, just one screw and you're done.
The only (optional) permanent modification is that you have to remove the original decals from the coffin and replace it with the new ones. (Not seen in my pictures)

This mod contains the tombstone cap and a sheet with two strips of decals for the coffin itself. On the inside of the tombstone is written whether it fits the original or the reproduction cover plastic. I tested the original.

The plastic fits very well. Due to small variations in the production of your machine and in the plastic cover, you may have to shave off a tiny piece of plastic from the cover to make it fit perfectly.

My only criticism is that the provided decals are lower resolution than the original and that the colors are slightly darker. A comparison with the original and provided decals can be seen in the pics. From Morpheus I understood that future versions will have brighter colors.

Thank you Morpheus for making this mod!

20170423_180539 (resized).jpg20170423_175722 (resized).jpg20170423_175645 (resized).jpg20170423_175833 (resized).jpg20170423_180021 (resized).jpg20170423_180003 (resized).jpg20170423_175615 (resized).jpg