Well turn my bsd on today and coils started firing then they stopped. So i started a game and opto sw that control coil wont kick out ball. Ive checked fuses and wire conection. I did notice board under playfield that opto plug into has no red led to show power. J118 sends power to board but not sure what sends power to j118 section of board. Thanks.

No added nothing. Just. Turned it on and acting weird. What fuse is that?

Ok all fuses check out. The red led light is not on the 10 opto board

I pulled 10 opto board and it smelled burnt. This is what it looks like.

15443842614216153876519308643867 (resized).jpg

So should i just replace cap and clean traces or buy new?

Traces under cap seem fine

154438522320810566317841044163 (resized).jpg

Ok i will order new cap and clean it up now should i just use same value or differant value cap. Ita a 35v 100ufd.

Thanks bro's will keep you posted when i get it repaired.

Damn thats crazy. I hope its just the cap.

So still waiting on cap to come in, but i was looking a circuit board. Just wondering if on top side is the banded side of D13 supposed to go to pos to c1.

20181213_181239 (resized).jpg

Screenshot_20181213-181304_Drive (resized).jpg

So the heavy green traces connect thats the pos + side of C1 and also on bottom of C1. thank you

Good news got my dracula working again. All opto working great. New 100uf cap fixed it. Thanks guys.