Bram Stoker's Dracula
Williams, 1993You're currently viewing posts by Pinsider terryb.
Click here to go back to viewing the entire thread.
Quoted from nikpinball:Ok, did you take a remote control to the receiver and did it say closed at all when you pushed buttons? did you hold up you cell phone camera to the transmitter to see if you see the led light? I'll help you from there
This ^^^.
Quoted from zaza:So, put machine in switch test T1 with J1 and J2 disconnected from 24"opto-PCB and have a resistor by the hand to trigger this board as shown in the picture.
Fantastic idea zaza. I will definitely add this to my mist opto troubleshooting guide.
Quoted from aobrien5:I think he just means the two that are holding down the white casing?
Correct, I'll fix the typo.
Radio Shack sells an IR sensor card (at least they used to--if not MCM Electronics sells one). It would be well worth the money to pick one up and use it to align the beam. Even with the camera trick alignment can sometimes be a pain in the ass.
You're currently viewing posts by Pinsider terryb.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/bsd-mist-woes-long-beam-opto?tu=terryb and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Banning, CA