I have read every post I could find on this error and I think I need some advise . I go into test 15 the ball unloads and loads fine , runs over to the left no problem , the ball travels all the way over to the right and just as it enters the right gate , it gives me a power error. The optics test fine, the left and right travel switches are fine . I checked the magnet board for crack solder , no problems there either. Unplugged and replugged in all the connectors.
I'm at a loss right now as the ball doesn't fall out of the gate , works fine , just comes up with that error as it enters the gate . Any ideas ?