Before I posted this I have looked through every long opto topic and have not been able to solve this one.
My long opto registers open with one small exception. It stays open when I break the beam except when I pull my hand back out of the beam it reads closed for a split second and then back to open.
I have:
-Replaced the 24 opto board with the Homepin board
-Replaced the optos.
-Adjusted/lifted the ball gates.
-Checked voltages at the opto board.
-Checked continuity of the white/red and green/grey
wires from the 24 opto connectors to the mpu
connectors.
The green led registers open and closed as it should on the opto board when you break the beam. Where should I check next? Thank you all!
-Hougie