Another post from myself trying to get the lineup A1....

I'm lucky; this game has been a no repair deal Since today.

Now The mystery hole doesn't register when the ball goes in. It don't starts mystery, myst, etc...

Today I added a colorDMD in it but it didn't work (colordmd is fried. My bad. Long story). I puted back the original dmd.

Many hours later I saw that the DMD fused fried on the board. No dots and the game was only flashing some leds. I changed the fuse and the game starts fine.

I need to figure out if my mystery hole problem is part of this.

What should I look first?
Thanks a lot
Lou

Update:
Now If I start a game and push one flippers it restarts

Ok. This morning the only thing the game does is trying to pass the "Testing" when boot up and it resets. Lights are all on and they shut with each reset.

The only thing I did with the dmd is unplugging it to test a ColorDMD I had on another game and wont work. I didn't even remove the original dmd in the game. Just plugged power and video cable on the colordmd (and it didn't work)

All fuses have been measured and work. Cables are thight.
TP1: 13.6
TP2: 4.9
TP3: 12
TP7: 21.4

Thanks for the Help

Helping bump!