This looks cool. Can you post a pic installed?

I'll order 2 of these when Big Daddy starts selling them. Thanks for making these.

Just bought 2. After all the work I've put into my Space Shuttle (and soon PinBot) this is a small amount to pay for the security.

Received and installed in my space shuttle. Works like a charm.

Installation tips:
Tighten up the connectors real good,
don't forget the black wire clipped from the capacitor,
and you'll need the instructions here: http://home.kpn.nl/p.koch3/laser_cue.htm and the pdf here: http://home.kpn.nl/p.koch3/Inkochnito_Bridge_Board.pdf.

The pdf shows you the wire to connector mapping.

I was able to install mine through the original rectifier holes. The new board lined up perfectly.

Here's a pic of the board in place. It's really close to the side but that's with the original mounting holesWP_20140420_08_37_42_Pro.jpg

Heres the before picWP_20140420_08_05_07_Pro.jpg

Yeah, I'll do that. I'll need to remove the original mounts and get the correct length metal screws. I'll feel better when the rectifiers are flush to the metal.

It's hard to see but there's .25 inch space between the wires at the side of the box. It's not as tight is it looks.

I did not. My games spend only a fraction of the time on so I wasn't worried about it.

Still in stock at Big Daddy. Just put one of these in my Time Fantasy

http://www.bigdaddy-enterprises.com/

My space shuttle is long gone. I'd expect 30vDC is acceptable. Are you noticing a loss of coil strength?