Got some help from Atari Jim on the villages bbs thought I would share his tip. Turns out I wired the ground and power wire and fried both coils diodes. Replaced diodes wired correctly and now the Bride is flipping like a teenager again.
Thanks Jim!
“Blue or Gray/Yellow dashed wire goes to the band side of the diode, outside lug and is power
Ground wire goes on opposite side (blue/purp or org)
EOS goes to gnd wire and center lugs.
Ohm the coil diodes and get 5 ohms or higher. 2 or less is bad diode
Ohm the eos cap when switch is open, should get 150 to 180 ohms (this is the hold winding)
If too low, disconnect 1 of the cap leads, check again- if better, cap bad, if same, coil bad or some other short, check your work.”
Make sure that EOS opens when bat extended
aj