I was just deciding whether to do this as well on BOP.

As far as the insert art coming off, wouldnt that just be a case of getting replacement inserts like available on Ebay (and vendors)? ebay.com link: Williams Bride Of Pinbot Pinball Machine Insert Decals LICENSED

If it is that simple, and your mylar is wasted, I would seriously think about the freeze spray option. There are also new full board mylar sheets available on ebay (and some of the vendors) to put back on if you want to go that route. I did the same on Pinbot a while back (took off the mylar) and a beat playfield went to being pretty damn good!

Thank you everyone for the great info and real life experience! Mine is not quite as bad as the picture posted by romulusx and I have very little wear outside of that--just where the ball drops and near switches. So I think I will leave mine alone, put some new mylar protectors on the spots that were uncovered from the factory, and shine it up. Thanks!

Bop_Wheel_(resized).jpg