So I picked up a BSD a few months ago. Been running into a problem with the right ramp. I would say about 50% of the time when you shoot the ball up the ramp, it will fly off it, smack something then come back down. I know that whoever had it before me had a bunch of incorrect screw sizes and missing ones as well. Does anyone have a map of what screws and nuts go where? I'm guessing this is at least part of the problem..

This is probably going to sound really stupid but....ok I took a look at my right ramp and did not see those pieces, but I also cant figure out where on earth they would go..I looked at the map on the manual and couldn't figure it out either. Could someone point me in the right direction? Thanks!

OK, so I looked again real quick...are they supposed to go above the right ramp where the ramp that lifts meets the rest of the ramp (for lack of a better description)

Here are some snap shots I took. Please excuse it being dirty, haven't had time to do a proper cleaning or track down new ramps..

drac_ramp.jpg

No, I have it, it is just not currently installed. The person who had it before me was missing a bunch of posts so it was sorta just hanging there. I just haven't gotten around to installing it correctly yet.

So I've run into an issue with my right mist gate. When the game boots the ball will fall out of the right mist gate (if its already in there) and fall into the trough. The game will then plunge a ball into the gate as it should but, it will hold there for a few seconds then the gate will open and the process will repeat itself. When the ball is in the gate you can hear a slight hum and it appears there is a magnet holding the ball in place and it is NOT resting against the metal side. If you fidgit with the game enough by starting a game without the ball in the right gate as it should and then physically putting a ball in there and then rebooting the game you can get the game to load as it should and play as it should. I've noticed that when the game boots and plays as it should you can hear the loud mist magnet turning below the playfield, when it doesn't there is no noise from the magnet. To make things even stranger, if you get the game to work as it should it will play through game after game with no problem. If you turn the game off and wait a few minutes and turn it on, no problems. If you leave it off for an extended period of time, such as an hour or more the problem will occur again...Any ideas what in the heck is going on? I can try to make a video of it if that will help..

Thanks! I'll check that out tomorrow...I'be got a bunch of caps from my monitor cap kits laying around. Maybe one will be the right value.

Replaced the caps this morning...probably the worst hack job of a repair I've ever seen or done. Lifted two pads and had to do some jumpers with traces left over from caps....seems to be working though, so thanks!

How on earth did you ever figure out that it was the caps?