Joined today. Machine is in players condition, normal wear spot, faded cab and a tiny bit of planking. It should clean up acceptably though.
"10 Opto board is shot, and will be replaced, it has attempted to have been repaired prior, unsuccessfully. The has also had some tomfoolery done inside the head, so I have onto issues (board), and no lights. Connections in the J120 - 128 region are cooled together from other connectors and spliced in via a screw header. The pinouts on the header used are i assume, salvaged from another machine as there is no wire colour continuity.. the wires have the length to make it to the socket, so i assume this was done rather than re-pinning a series of connectors properly
Someones gone snipping at some point for an unknown reason.
If anyone could post a few photos of their connectors in this area it will help me verify against the manual and re-pin/repair the section.
IGeEADD1Q1KwD+Xapq+Sdg (resized).jpgLMpmVrCgSLmZR9o0R4obUA (resized).jpgY5Qm9aSKQTG68QMamDsbFQ (resized).jpgcP1ISWRwSaav6%us6zggyw (resized).jpg