Machine: Bride of Pinbot, The
Williams, 1991You're currently viewing posts by Pinsider MrBally.
Click here to go back to viewing the entire thread.
You also need to remove the two Philips head screws on the back side of the thumper bumper bracket that secure the "upper coil stop" in place.
Then remove the coil by sliding it towards the playfield and pull it outward. Disconnect the wires as appropriate.
With a seized solenoid plunger thanks to a burnt coil (which means you likely have a fried transistor on the Driver Board), I remove the screws, slide off the ring & rod assembly and then use a large screwdriver to pry the coil out. No worries destroying the coil in the process. Be sure you have a new coil sleeve as sometime they are not included with replacement coils.
You're currently viewing posts by Pinsider MrBally.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/bop-solenoid-13-removal-how?tu=MrBally and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Paradise, NV