You're currently viewing posts by Pinsider jfesler.
Click here to go back to viewing the entire thread.
My distributor got this from Steve Ritchie. No time for me to pursue this until the weekend.
This is a symptom of a missing washer in the stack on the flipper shaft underneath the "ironing board."
It can be fixed on most machines by adding a 1" dia. X 1/4" hole washer under the ironing board. Most games included this washer, but I guess not all.
Even without the washer, loosen the hex screw at the flipper shaft and remove all up and down play in the flipper. Re-tighten and check if ball can be stuck behind the flipper.
Regarding that ball trap under the top right flipper, Steve Ritchie had said:
This is a symptom of a missing washer in the stack on the flipper shaft underneath the "ironing board."
It can be fixed on most machines by adding a 1" dia. X 1/4" hole washer under the ironing board. Most games included this washer, but I guess not all.
Even without the washer, loosen the hex screw at the flipper shaft and remove all up and down play in the flipper. Re-tighten and check if ball can be stuck behind the flipper.
Finally got time to work on this.
When looking at the schematic, there is no washer.
On mine, there was a washer above the 1" plastic spacer and below the "plug". However, that spacer was a 0.5" outer diameter. Replacing it with a 1" washer seems too have worked. There's still a bit of play in the plug, but not enough to trap the ball.
Quoted from TREX:2)The assembled unit for upper playfield flipper is clearly an issue and needs adjustment. Ball will trap under the white plastic fitting below the flipper.
From SR himself:
This is a symptom of a missing washer in the stack on the flipper shaft underneath the "ironing board."
It can be fixed on most machines by adding a 1" dia. X 1/4" hole washer under the ironing board. Most games included this washer, but I guess not all.
Even without the washer, loosen the hex screw at the flipper shaft and remove all up and down play in the flipper. Re-tighten and check if ball can be stuck behind the flipper.
Did that with mine, totally fixed it.
You're currently viewing posts by Pinsider jfesler.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/black-knight-swords-of-rage-club-honourable-knights-only?tu=jfesler and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.