Game code!
LE V1.02 - November 23, 2020
==========================
Fixed:
- "TOPPER EFFECTS IN ATTRACT MODE" would not prevent the topper motors from
moving during attract mode. This has been fixed.
Tweaked:
- Retro Multiball scoring changed.
- Base values for each shot start at 350,000.
- Scores increase by 25,000+5,000 for each shot made.
- Various sound and music tweaks.
- Flipper Power adjustments now take a decimal value from 100 to 255 (max)
instead of the SOFT, NORMAL, HARD adjustments. The default flipper strength
values remain the same and at the designer's recommendations, but now give the
operator more precise control over flipper coil strength adjustment.
New:
- Added support for DJ MIXER
- Choose between the following playlists:
- Black Knight: Sword of Rage original soundtrack
- Black Knight: Sword of Rage alternate soundtrack
- Retro Black Knight soundtrack
Moved to System 2.63:
- New Standard Adjustment "START BUTTON ATTRACT MODE ILLUM."
This adjustment, which is only available and active when the game is in FREE PLAY mode, controls
the behavior of the Start Button Light.
Values are:
"ALWAYS OFF" - Start Button Light is always off when in attract mode.
"BLINKING" - Start Button Light will blink when in attract mode. This is the DEFAULT and previous behavior.
"ALWAYS ON" - Start Button Light is always on when in attract mode.
- Updated to nodeboard firmware v0.65.0
- When starting a game ramp the backbox GI from "ATTRACT MODE B.BOX BRIGHTNESS" to
"GAME PLAY B.BOX BRIGHTNESS".
- When ending a game ramp the backbox GI from "GAME PLAY B.BOX BRIGHTNESS" to
"ATTRACT MODE B.BOX BRIGHTNESS".
- Update TARGET_GAME_TIME adjustment to ensure a minimal ballsaver even after
the target game time is met.
- Do not display LOCATING NODE BOARD at boot when coin door interlock switch
has disabled node board power.
- Improve backbox and cabinet audio synchronization.
- Update the HSTD reset counter when the Standard Adjustment is changed.
- Updated 10 band graphic EQ to have 15 slider settings (was 120) above/below the
neutral center line.
- Rename Util->Volume->Speaker Balance to Speaker Fade. This adjusts the volume
levels of the cabinet (front) and backbox (back) speakers. The term Balance
was misleading and implied adjusting the level of the left and right backbox speakers.
Moved to OS V2.0.18