Hi all... since everyone was complaining about forgetting where the magna save button is.. I thought this was something that would help and also look good doing so..something I came up in the last few days..I’m planning on making a small run on these if there is enough folks interested.. this is the prototype so I will make some changes . Feedback is welcomed. This is a 3 D printed item.
What do you guys think?
3F7EC1F2-15D3-401A-8D89-780A596AA4F5 (resized).jpeg702C2ED1-1AC5-46EB-9F1C-C16DFEDDE018 (resized).jpegA8F61319-9BED-4649-8DE5-A57BF09FEC77 (resized).jpegC66811F9-3557-44B2-B255-1246CA2F2B96 (resized).jpeg

Thanks! And Yes .. it’s Black Knight.. your suppose to get a little bloody.. the depth is something I am going to adjust for sure. Initially it was flat and flush with the lock down bar..it was my sons idea to make it deep and angled..My goal is to have the button just pop out of the top. The studs are not sharp but yeah I can tone them down as well..

Thanks all for the feedback... revamping..