Just set up an NEW Super LE for Pinaholic and during the post transit pre-power up inspection I found this one and only one issue that I thought I would share for others to check on their machines. Its no biggie just something to look for.
The wire harness from a topside assembly and another from a lamp board was routed near the lower popbumper with wires actually caught in the Yoke. I needed a zip tie to clear the wires from the popbumper yoke and ring rod. Be sure to check this area when your machine arrives during the usual post transit inspections that you should do.
One more thing and hopefully a really rare occurence was that a ball got stuck behind the crane on top of a microswitch. This should be an easy fix if it will happen often. Stern needs to install some anti stucky ball device there such as a horizontal post or plastic covering/shield.
6 (resized).jpg
5 (resized).jpg
4 (resized).jpg
34 (resized).jpg