Mars, PA
Such a great game....I'm on the request for a playfield and could use a backglass!
(Topic ID: 63891)
You're currently viewing posts by Pinsider drjoe.
Click here to go back to viewing the entire thread.
1 month later
Quoted from Arcade:If anyone in the club could post a photo of the bottom right side of their power board, I would really appreciate it.
I am trying to get the correct wires put back into molex plugs for when my new power board arrives.
I have a thread in the tech section about it and I have learned that the two large yellow wires go on the far right in the large plug.
But I am not 100% on the 9 pin and 2 pin shown in this photo.
Thanks.
Looks like your GI is just twisted together and taped into a "circuit" which you could keep that way even with a new power supply board if you wanted. The thicker yellow wire(s) is/are the GI input and go into a connector that is missing from your board. It should be under the relay. Your empty 9 pin connector (4 + plug + 4) is the output for GI (the right 4 pins have seen some heat and is where the other wires in the GI "bundle" were connected).
Quoted from Arcade:Thanks. What goes on the 2 pin on the left?
I believe that is empty on Barracora. I think it powers a relay in some system 7 games (Defender comes to mind). My Barracora is on location and I can't get to it to check 
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider drjoe.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
