Hello y'all I'm having some technical difficulties with my TAF sure could use some help! So after playfield swap and new everything I got this up and running going through the test sequence testing all coils ,switches the Thing motor did not work . Everything else looked good I found the fuse was blown keeps blowing a fuse on the auxiliary driver bourd . Now when I turn it on it does have a code says check thing opto up I have replaced that I also checked the motor it works like it should it probably just didn't read the opto because Thing didn't go up or down . Well if everyone could help out I would be grateful..thanks

I also would like to ad I didn't have 3 amp fuze I tried a 4 amp Fuze breaker in that auxiliary driver board which caused A Flash on my driver board upper right hand side now it no longer works luckily I had another game that I could pull one from to test but things still. I did not hook up that auxiliary driver board after that.
I'm very leery of this I don't wanna fry my driver from getaway......

Ok i had similar issues one time after changing ont cabinets flipper switches did you make any upgrades?

it should be in the manual look through it closely . If not ill check when I get home.