You're currently viewing posts by Pinsider spidey.
Click here to go back to viewing the entire thread.
I finally resolved my issue with the Thing dropping the ball right after it picked it up. Removed the wire harness, cut most of the old wire out, leaving only about 1" from the coil and from the molex connector, and soldered in new wire. Now it holds the ball firmly. Whew! It had always been flaky but one day it dropped every ball, so that was the final straw.
Wasn't terribly difficult but wasn't sure exactly how to do it. Once the bolt is unscrewed from the hand, you can just pull the coil and the harness comes out though the hand ( of course you have to disconnect the harness from below first). The molex connector has just enough space to get through there.
Quoted from Neal_W:magnet fuse mod
warm/sunlight white frosted LED GI
cliffy protectors
And GI OCD because dimming is used in Seance mode.
Quoted from lhammer610:I have yet to see where an OCD board makes a difference for me in GIs, but your opinion maybe different.
GI OCD allows your GI to dim, so it’s not just about reducing a/c flicker. You have to enable GI dimming in the adjustments. In TAF it’s used in Seance mode. In STTNG it’s used when you’re aiming your canon to start Borg multiball. If you don’t have GI OCD and you enable GI dimming you’ll just get a strobing effect. Try it out in the test menu with each level of GI dimming.
You're currently viewing posts by Pinsider spidey.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/bally-the-addams-family-club-tafmembers-fans-welcome?tu=spidey and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.