Aliquippa, PA
I am having an issue where after about 100 or so plays, the two screws that hold Thing to the motor need tightened. Any fix for this? Buy longer screws and add a lock nut?
(Topic ID: 78709)
Linked Games
Addams Family Gold (Special Collectors Edition), The
Bally, 1994-
Addams Family, The
Bally, 1992
Topic Gallery
You're currently viewing posts by Pinsider jtreehorn.
Click here to go back to viewing the entire thread.
Quoted from DudeRegular:Try a bit of loctite?
I was thinking that, but then thought the lock nuts would probably be easier to disassemble if need be. IDK.
8 months later
Showtime: I just noticed that the left side slings and out lane lights stay lit and do not do the lightning effect like it is supposed to. The right side is fine. Any suggestions on where to start looking for the problem?
Quoted from squad8:Run through the general illumination test manually. I recently got a Addams Family, and had issues with the right side. Someone had replaced the GI connector, and wired the right side to a unused GI circuit.
Good Luck
Thank you
Promoted items from Pinside Marketplace and Pinside Shops!
Vancouver, BC
You're currently viewing posts by Pinsider jtreehorn.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
