I just acquired this machine I know that it worked for the most part before it was stored.
When I turn it on I can hear humming but nothing lights up.
I have I setup manual that says if this happens ( on or more of the 5 anti cheat relays are not making contact. 2 are located on the front door and 3 are on the mounting plate) I cant locate any on the front door. Is there a problem if I somehow lock anti-cheat coil in the picture on. I briefly connected it and it started making noise but then got worried after a second and figured I would check here first. Will a fuse jus blow if a screw up or should I be more worried?

Also in one image you can see an orange and white wire I'm pretty sure it goes to an area that says third coin slot. I assume this mean this wire does nothing and I don't nee to worry about it.

PXL_20210511_234305139 (resized).jpg

PXL_20210512_182317118.MP (resized).jpg

anti cheat (resized).jpg

wire (resized).jpg

Thanks for you replies not sure what happened what when i looked the anticheat relay on for a while then let it unlock that machine seems to work mostly. space station wont move and beam c doesn't work at all. also whoever had it before the las person im pretty sure installed wrong size flippers, they are 3 inches i think they should be 2? the is no switch under the machine there is an on off switch on the front on the machine just under the plunger not sure who would have put it there but it works. also the bell in the back of the machine is gone

PXL_20210511_225102748.MP (resized).jpg

PXL_20210511_225116272.MP (resized).jpg

PXL_20210511_225142240 (resized).jpg

PXL_20210526_215839700.MP (resized).jpg

PXL_20210526_220136552 (resized).jpg

Yes there was a rubber ring I assume since you pointed it out that it should not be there so i removed it. There is no rubber ring around any of my mushrooms I assume you are saying that there should be rubber there from that guide

Hi all so my current problem is 2 things nothing for beam c works on the playfield. I assume its a leafe issue. Similar issue none of the move space station on the playfield work when i trigger them. Here are some images of the leaves for beam c, as you can see they are very warped. I have noticed they they never touch when cycled. does someone know which should be connected when the machine is on or is there some other thing i can be doing.. I can not make the playfield work when the mounting board is raised to test them one by one. It seem like a bad idea to keep on raising and lowering the board to test each one t

PXL_20210611_000732395.MP (resized).jpg

beam c lefs (resized).jpg

c leafs (resized).jpg