Hey Guys,

Not sure if this is the right forum for this, but I've finally started a video series I've been planning for a long time which will document the pinball repairs I do from day to day. The first edition is done. I though some of you might enjoy watching and might even learn a little bit about pinball.

Constructive criticism is encouraged, but let's please keep it positive. I'm doing this stuff for fun and to try to help some people

Thanks for the feedback. I agree about the intro.

I debated about leaving stuff like the GI lamps on the playfield in there but I'm going to keep doing it in future videos because that's the reality of repairing these things. Sometimes what seems obvious later isn't obvious on first observation. Then there are times where you'll luck into repairing something complicated right out of the gate. It wasn't a bad thing to go through the lamp driver board. Just wasn't totally necessary. Major blunders probably won't make the cut though

I was selling them for a while on PinForge.com, but I ran out of assembled boards so I shelved it for a while. I do have another batch ready now though, so I can sell you one. PM me your address and I'll give you a total cost.