Quoted from reconsider59:Another question for long-time havers of this particular pin: the one I just acquired has a lot of wear over the little display that's right above the flipper gap (see photo). I can tell that's from the display insert not being flush with the playfield. The screws don't feel flush with the display itself, either.
Is this usual? Or are these after-market screws, and this display isn't adjusted properly, so I should figure out how to kind of level everything out? Any guidance greatly appreciated!
[quoted image]
Any tricks or suggestions on how to level these things? Mine is a little too low and the ball will stop on it and get stuck on the edge.