Hi all
I have a bally mpu for a kiss that has been converted with eproms. Board booted and worked fine up until recently. It boots properly with a 5v and 12v power supply but is locked when installed in a game with 43 volts present. If installed in a game with the fuse for the 43v removed i get the flicker and up to six flashes, reinstall the fuse and its locked on. If i turn the game in and off i will sometimes get to the fourth flash before it stops with some solenoids locking on and some controlled light locked on as well. I checked everything associated with the 43 volt circuit and it tests fine. Again, it did work before so i know its jumpered properly. Any ideas? I dont have access to an eprom burner or another set of eproms.