While the ICs in the AUX lamp boards frequently go bad. Your mixed results sounds like soldering mistakes.
You're currently viewing posts by Pinsider barakandl.
Click here to go back to viewing the entire thread.
While the ICs in the AUX lamp boards frequently go bad. Your mixed results sounds like soldering mistakes.
I probably have a bunch of these aux lamp boards. If you need a rebuilt and tested good one, let me know.
There is a few versions of this AUX board with different components. Make sure everyone on same page.
Clock pin should be lamp strobe 2 i would imagine. Lamp strobe 2 should be the inverse of lamp strobe 1. Both lamp strobes should always be pulsing. Probably near the zero crossing timer.
Lamp strobe 1 is not used on the aux board. You want lamp strobe 2. It is P11 on MPU j1.
The rest of those voltage readings you can assume are pulses which is valid.
Quoted from cody_chunn:I wouldn't do any board work yet. That Pin 3 never getting above or below .16 has me concerned. I think we should meter the other lamp strobe and see what its behavior is.
All the rest of the lights seem to be working properly?
Also a cheap logic probe will increase your troubleshooting abilities exponentially.
amazon.com link »
There have been threads where some were suggested here as well.
The lamp strobe pulse is near zero crossing. So it is really slow which I think makes pulse will look like very low volts on a DMM's average reading. Probe or scope will tell for sure.
http://www.amazon.com/Elenco-Electronics-LP-560-Logic-Probe/dp/B000Z9HAP4
+2 on this logic prob. I like it. After getting used to it, you will start relying on the sound it makes.
You're currently viewing posts by Pinsider barakandl.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/bally-kiss-aux-driver-board?tu=barakandl and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.