Hi
I was hoping someone who has a Future Spa or similar could take a photo of the three connectors for the rectifier board and also the top right connector on the driver board. Mine had some horrible hacks and I don't know which colour wire goes where. I looked at a rectifier help page online for another Bally of the era but the wire colours were different. I've replaced the rectifier board with a nice new Weebly board. Oh, I'm still chasing the rectifier mounting plate if anyone has one to sell... Thanks.

IMG20170717144048 (resized).jpg

IMG20170715132540 (resized).jpg

IMG20170715132508 (resized).jpg

IMG20170717144004 (resized).jpg

Steve Kulpa's page was the one I mentioned that has different colour wiring to mine...that's why I was hoping someone with FS could take a pic. I'm not great at reading schematics but I'll check out the manual...thanks.

Thanks Pecos, got it all sorted now. I attached a pic of the board and my wires now in order ready to pin. Thank you for sending me those pictures. Can you tell me if the top right driver board connector arrangement in my pic is correct and is your rectifier board held on with just the four plastic tabs? I'll send a pic when it's all back together...still trying to find a mounting plate for the rectifier board if anyone has one.

IMG20170718190701 (resized).jpg
IMG20170718190234 (resized).jpg
IMG20170718190226 (resized).jpg
IMG20170718190306 (resized).jpg

Can someone post a picture of the top right connectors on the driver board showing the wiring order so that I can check that mine are in the correct order as a couple of mine weren't connected? Thanks.

Hi Pecos,
Thanks for the photos. I've got Ultimate MPU and Driver boards and Weebly Sound and Rectifier boards and original lamp boards. Here's a pic you asked for. The rectifier board is in the silver bag lower left because I don't have the mounting plate for it. Have repinned two of the three rectifier connectors so far...I ran out of pins : )

IMG_20170720_201405.jpg

Thanks, I'm in the home stretch now...new boards and only two connectors to go and the wires to solder to the back of the Reccy board and I'm done. I can't wait to play it!

Downloaded the manual, seems to be some pages missing. I think they only sell as a 'bundle' with transformer/rectifier assembly for $249. They are also out of stock.

All fixed and playing great!
Btw...is there a setting to disable/enable the knocker unit on Ultimate boards as it's not firing.

I'll have to check that...when I bought mine the knocker coil was burnt out and one of the wires disconnected so I'm guessing it had caused some grief on the board. I've replaced with new coil and new board and connector replaced on that fifth wire.