Take a look at the video, and tell me if the contact gaps are correct? New coils, flipper rebuild kit and it still runs bad. What am I missing ?
(Topic ID: 258171)
You're currently viewing posts by Pinsider seeburg220.
Click here to go back to viewing the entire thread.
Quoted from pinmike:Not good,go over your wiring on that EOS switch and the blades are properly adjusted leaving it like that will burn up the coil and do more damage
Does the gap look okay to you ?
OK. I think I fixed it. I believe the problem was that the leaf switch was opening too late so I bent the entire switch to open just slightly earlier, before the flipper was fully extended.
It seems to of cleared that problem up. I’ve never had so much trouble with an end of stroke switch before.
Quoted from pinmike:It happens sometimes but just make sure while your playing a game if you hear loud buzzing to stop right away so you don’t burn up the coil and transistor.
No buzzing anymore and it's an EM, so no transistors to fry.
Promoted items from Pinside Marketplace and Pinside Shops!
Charlottesville, VA
You're currently viewing posts by Pinsider seeburg220.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
