I just got an Eight Ball Champ, wahoo! My first 6803.

Having a few issues -

1) when going into test mode, I get 94, with a 13 which I think means that the right rollover switch is closed, however, that switch is definitely NOT closed.
2) The top score displays have the far left digit ghosting on, with a comma. The credit/ball and 2 lower displays don't seem to have any issue.
3) When starting a game, no ball is sent to the shooter lane, flippers dont work, have to just reset the game, and it goes to attract more no problem.
4) On boot, it says "8 Balllll...3 ball" (not sure if thats an indication of an issue)

Any advice would be greatly appreciated, thanks in advance!

-MikeP

IMG_9444 (resized).JPGIMG_9446 (resized).JPGIMG_9449 (resized).JPG

RESOLVED (MOSTLY)I just got an Eight Ball Champ, wahoo! My first 6803.
Having a few issues -
1) when going into test mode, I get 94, with a 13 which I think means that the right rollover switch is closed, however, that switch is definitely NOT closed. THIS WAS DUE TO THE CAPACITORS ON MULTIPLE SWITCHES
2) The top score displays have the far left digit ghosting on, with a comma. The credit/ball and 2 lower displays don't seem to have any issue. ISSUE ON THE DISPLAY (4542 IC or level/shifter)
3) When starting a game, no ball is sent to the shooter lane, flippers dont work, have to just reset the game, and it goes to attract more no problem. THIS WAS DUE TO THE TILT SWITCH BEING CLOSED
4) On boot, it says "8 Balllll...3 ball" (not sure if thats an indication of an issue) NON ISSUE
Any advice would be greatly appreciated, thanks in advance!

Inkochnito Ah, ok. I tested continuity between the 2 leaves of that switch and it tested open. Would that still be the case if that capacitor was bad? I also disconnected the playfield switch connector at the cpu and I now get a 15 (tilt) switch is closed. I also checked continuity on the 3 tilt mechs that I could find and they were all open.