Enfield, CT
I have a bally city slicker that wont start a game. It boots into attract mode fine and it has all the balls it needs but it wont start at all. Where do I start to look on this?
(Topic ID: 158761)
use switch test to make sure it really sees the balls in the trough. 6803 games, or at least the few i messed with, dont give a missing ball message. They just refuse to start.
Good idea to clear out the RAM too. You might have a bad value stored in the credit audit or something like that.
To reset the RAM on a Bally 6803 game:
Hit "Test", to enter operator mode.
Hit "A" until "Feature Options" is displayed.
Hit Enter.
It will say "Reset Factory Is".
Hit 6, then 5, then Enter.
Hit "Game" to return to attract mode. You'll know it worked because it will take longer than usual to reach attract mode, and the display will flicker slightly as the computer clears the memory (this is normal).
Quoted from snakesnsparklers:To reset the RAM on a Bally 6803 game:
Hit "Test", to enter operator mode.
Hit "A" until "Feature Options" is displayed.
Hit Enter.
It will say "Reset Factory Is".
Hit 6, then 5, then Enter.
Hit "Game" to return to attract mode. You'll know it worked because it will take longer than usual to reach attract mode, and the display will flicker slightly as the computer clears the memory (this is normal).
This. Had the same issue on my dungeons and dragons. This worked.
Promoted items from Pinside Marketplace and Pinside Shops!
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
