Beginner learning the basics of board repair, was given a 6803 board that looks almost new. The guy had pulled the reset switch and a few resisters off of it, i replaced all missing parts and installed it in my working pin and im not getting a led blink at all on power up. Using http://www.pinrepair.com/6803/ thread i checked U1 pins 4,5,6 which are suppose to be 5v but im at 3.8 on pin 5, pin 6 reading 5v so from what i read the reset should be working. I believe U1 eprom maybe bad as i also noticed it getting hot so i want to replace it before going to deep.
When reading the numbers on the eproms how do i know what to get? Is there a guide in identifying roms replacements? I recently bought a eprom reader/burner so looking to try it out updating some roms.