(Topic ID: 92877)

Ball kickout consistency

By Boatshoe

7 years ago



Topic Stats

  • 2 posts
  • 2 Pinsiders participating
  • Latest reply 7 years ago by Flippers_com
  • No one calls this topic a favorite

You

Linked Games

Topic Gallery

View topic image gallery

stuck.jpg

#1 7 years ago

Hi,

I have a STTNG, and the kickout strength from the ball trough is all over the place. Sometimes It comes out so hard, it goes straight back into the trough. Sometimes It pops out just perfectly. Othertimes it dribbles out. This normally wouldn't be an issue, except, for this particular game... The below picture happens more often then I would like. It really messes everything up.

I have already tried adjusting the height of the coil, and it doesn't appear that anything is loose. I have also bent the ball guide and it has not solved any issues. Is there something else I should be looking at? Any ideas?

Thanks!

stuck.jpg

#2 7 years ago

Follow the schematic to find the pin connector that controls that solenoid. I'd suspect a bad pin in the connector making an intermittent contact - so simply replace that connector with a new crimp style Molex using Trifurcon pins and a good crimper or(and) careful soldering of the pin to the wire before crimping the insulation. Very tiny amount of solder!

John :-#)#

Hey there! Got a moment?

Great to see you're enjoying Pinside! Did you know Pinside is able to run thanks to donations from our visitors? Please donate to Pinside, support the site and get anext to your username to show for it! Donate to Pinside