On my White Water the backglass is very hard to get in and out. It starts very smoothly but when I want to lower it into the speaker panel I have to use quite some force. It took a while to figure out what was wrong but it seems that the two wooden vertical supports are about 7mm or 1/4 inch too far forward.
So you basically need to bend the backglass to go in the upper and lower slots.
I'm not quite sure how to solve this. I could try to chisel the front part of the supports off but I'm not sure that would look very nice. Maybe I can remove the supports and then place them a little further back. But how do I get them off? They seem to be held in place by three staples but maybe also glue.
Any ideas? Thanks!