Quoted from Zablon:I was fiddling with this yesterday. It seemed from what I could tell the connectors are held together (touching) and the ball hitting spreads them. The foam is wedged against them so they do not activate easily. I am not 100% sure this is how they are set up but the initial look seemed to be like that. If this is how it really is, cutting back a little foam should help the issue.
I would have expected them to have a gap, and ball hit makes the leaf touch, and the foam prevents them from going too far...but... will require some more investigation.
Also, they put the stickers over the top of (rivet?) but it's pointed. These stickers won't last long as there is a huge bump under all these stickers. Normally the rivets are mostly flat inside.
I had to adjust every single leaf switch on my game to make them register without needing a hammer to activate them. They should have been adjusted from the factory (this is a new in box pin afterall, not something off a route). This in addition to fixing numerous mechs that were put together incorrectly and also the right flipper switch needed lots of work to function like its supposed to. My game is a Jan 2021 build.
Phoenix, AZ
