Allentown, PA
I’m having an issue where the ball gets stuck under the spaceship after defeating it. A good shake will release it to the VUK but it’s registering as dirty pool or a lock when that happens. Any thoughts? Thanks
(Topic ID: 192072)
Linked Games
Attack From Mars (Remake - Classic)
Chicago Gaming Co., 2017-
Attack From Mars (Remake - LE)
Chicago Gaming Co., 2017
-
Attack From Mars (Remake - Special)
Chicago Gaming Co., 2017
-
Freddy: A Nightmare On Elm Street
Gottlieb, 1994
Topic Gallery
You're currently viewing posts by Pinsider jamjam.
Click here to go back to viewing the entire thread.
Quoted from whthrs166:I had this happen to me. The ball hangs up on the switch lever sometimes. You have to push that lever down some. There is an adjustment on the switch mount under the play field. 2 screws. Make sure you do not reduce the sensitivity of the switch so that the ball wont activate it once it runs over it.
Thanks much! I’ll take a look for that adjustment
Quoted from GreenMarine:Trying to install Cliffys and this little bugger won't come out. Do I bang or unscrew it out?
I’m having the same issue, even with vice grips won’t come out
Quoted from Higloss67:Remove the nut off the back of it and use a small punch and carefully hammer it out. I had the same issue and was able to remove it with zero damage.
Ok thanks, will try that
1 week later
Quoted from LTG:If both optos work, then check it's fuse in the head. F115, if that is good, then check the coil lugs for poor solder joints.
LTG : )
Optos check okay.
Not certain but F116 actually looks blown, F115 looks okay?
1 week later
Quoted from Mark000:Hi all, Just set up my AFTr LE, After having approximately 20 games on it the Left flipper stopped working.
Same problem, hope CGC gets a fix soon, no fun having a new machine sit broken
Quoted from bitpatrol:would like to turn down my flippers though as it's hitting a tiny bit hard.
It's best to leave them at default until they release a software fix
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider jamjam.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
