Anyone looking to move on from their AFMr SE within a few hours driving of Washington, D.C.?

Joined the club today. Stock SE, no mods as of yet.

Where should I start? What are the have to have mods? Best place to purchase said mods?

Relatively new to the party and love my AfM Se.

Problem i was wondering if anyone had a similar situation and any suggestion on a fix. 10-20% of the time the ball comes down the right wire form toward the right flipper, the ball is traveling so fast and with so much force that it flies off the ramp and either into the drain or completely over the flippers to a middle drain.

It’s almost as if the wire ramp isn’t deep enough to keep the ball on the ramp.

Anyone else ever experienced this? Any suggested solution?

Would you mind adding a pic or describing nut location that did the trick?

I’ll give the nut adjustment a try. If that fails, on to flipper strength and weather stripping.

Thanks for the suggestions. I’ll let you know how it goes.

As I mentioned a few posts back, I’m relatively new to the club.

What’s the most updated code version number?

I did google it. Couldn’t tell from the CG site whether that was an example of the process or the actual version. Thanks for the confirmation.

Any recommendations for best pin blades for AfMr SE?

Installed FlyLand Designs new art blades to my AfM SE. My pics don’t do them justice. They look outstanding. Bright, colorful.

1638BB86-8A9E-42CA-8FF5-8F21631A55D1 (resized).jpeg

24016BE2-063D-4A6A-877E-F6179AA75DA5 (resized).jpeg

356A01D8-364D-4BF5-9AF3-F2132148FE35 (resized).jpeg

D89E545F-89B9-47B3-BF33-651541917F79 (resized).jpeg

I’m trying to make sure I have the latest update. When my pin is booting up it shows Rev 1.1. Is this the latest?

Thanks for sending the tutorial video on how to get to the CG menu. Very helpful.

To confirm, the thumbnail of the video, ver 1.0.0 is current?

Anyone replace their speakers on remake SE? Worth doing? If so, any recommendations?