I am working on Bally Viking and I am replacing the rectifier board.
I am about to connect E1 and E2 although have noticed that the current configuration is different to the schematics in the manual and connection/cable table at https://pinwiki.com/wiki/index.php/Bally/Stern#How_To_Hook_Up_a_Bally_AS-2518-18_Rectifier_Board.
I have the following
- yellow wire from Transformer lug 5 going to E2
- red wire from transformer lug 1 going to E1
Ignoring the colors should it be
- Transformer lug 5 going to E1 (currently yellow wire)
- Transformer lug 1 going to E2 (currently red wire)
I hope this make sense and any advice is appreciated.