Im having the same problem with my STTNG in CT. Id appreciate if someone could tell me where to start looking!

Have you tried resetting the connectors on the power driver board? There is a list. I know someone will post a link soon. I am on my phone and cannot post a link with it.

Is it the coil, board or eos that is shorting it. Does it matter which order it happens in? Like hold the left side and press the right and does it blow vise versa? Just curious what troubleshooting has been done so far. May make it easier to narrow down.

http://www.pinwiki.com/wiki/index.php?title=Williams_WPC#Game_resets

LTG

#1 problem that will cause this is low line voltage, meaning that the power from the wall is poor. Before you mess with anything check to see if you have less then 120/119 volts, if so this is high likely hood of the issue. Stiffen up your neutral on the house electrical.

So are you saying the bridge rectifiers and caps were replaced?

+1 on this I have to have my STTNG plugged into a completely different circuit than my other pins for it not to reset, and can not use my monsterr surge protector on it st all.

Do check all connectors - I also had a bad connection where wire was 90% out of the connector. Even after fixing this, still need different circuit.

Just for emphasis...
http://www.pinwiki.com/wiki/index.php?title=Williams_WPC#Game_resets
--
Chris Hibler - CARGPB #31
http://www.Team-EM.com
http://webpages.charter.net/chibler/Pinball.htm
http://www.PinWiki.com - The new place for pinball repair info