Paradise Valley, AZ
I've been waiting for this.....
(Topic ID: 39420)
It's still in (slow) progress. I just got a (p.o.s. but working) little solder reflow oven to do the backbox board with surface mount and keep it as small as possible. Assuming that goes right, which it should since the board logic didn't change, I'm going to expand the test group a bit more just to make sure everything is covered before some sort of real release. Still planning/hoping for a wider release during Q1.
Thanks for the patience everyone. I'm very slowly getting the hang of hardware - where you really need to measure twice, cut once compared to the software development world I'm used to.
Quoted from pinlawyer:I've been waiting for this.....
So have many others and for a lot longer then you 
Quoted from jasonpaulbauer:If you need any volunteers for the test group, I'd love to try it.
lol...You, me, and the rest of Pro owners on planet earth....and beyond. 
Promoted items from Pinside Marketplace and Pinside Shops!
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
