Quoted from dmacy:Wire guide install. These are small and the clear is really rough so I went with a hand job countersink to get the hole large enough to not chip when drilling. Check the wire size, get a drill bit to match with a stop and drill only deep enough to get a few mm down. I want the tighter hole to still “bite” when fully seated.
Blow the holes out, add some of Ron’s glue and tap, tap, tap it in just deep enough before it comes through the bottom. A ball will be the best way to set these in my opinion.
One down; four to go! Right side is now completed.
[quoted image][quoted image][quoted image][quoted image][quoted image][quoted image][quoted image][quoted image][quoted image][quoted image][quoted image]
[quoted image][quoted image]
Thanks for showing those photos. I am getting close to the point of installing the guides... and now it should be straight forward