Anyone have a picture of the back of the monster slide plastic? I have the plastic and two cut wires. Not sure what socket/socket bracket goes on the back and can't find a good picture.

Thanks in advance!

Picture is perfect . I need to get a little mini pcb for a 555 twist socket. Thanks big bob!

Great. Now I need to find this single lamp pcb 5768-12312-00. Can't find it anywhere.

Bump

It would.. if I could find one. Anyone point me in the right direction. I've looked on:

Marco
Bay Area
PB Resource
Action Pinball
Pinball Life
Great Plains

I can't find it on any of those. I've emailed them to see if maybe they just don't have it on their website but...

Missing entirely. I could make one but I'm a stickler for original parts if I can find them.

I'm convinced the Australians are hoarding all the rare and obsolete parts.

Screws holes don't look like they'd line up.

worst case I get one of these bad boys and get to moddin.. $1.25 better than $8.75 if it's not gonna be OEM anyway!

http://www.marcospecialties.com/control/keywordsearch?SEARCH_STRING=077-5029-00

I think I may have a line on one though from a pinsider..

So close to completeness and then I can move on to the Whirlwind.

EATPM_-_Back_in_the_Cab_Again_008.jpg