What prep was done before the plating? How was the corrosion removed first? Plating will brighten the surface but not change the surface shape at all, it will lay down on top of what is there.
You're currently viewing posts by Pinsider bjm-maxx.
Click here to go back to viewing the entire thread.
What prep was done before the plating? How was the corrosion removed first? Plating will brighten the surface but not change the surface shape at all, it will lay down on top of what is there.
Have been following your thread with great interest. I am curious how you restored/finished the rectifier board mounting plate? It looks like a brushed finish. I have one I need to do something with and it is quite rusty.
Also, where did you get pins and connector bodies for that board? I had a swap a pin the other day and the normal .093" pins/sockets were too big to fit into the housing of J3 and the socket was too loose on the pin.
I am curious about how you reattach your wiring, you have left a good amount of wire on that target on the right which makes it easy to identify wires. Do you do a splice or move the harness cut end to the coil and hope there is enough slack?
I have an Embryon that has the same style pop bumpers, it makes so much more sense than the traditional type. My Xenon came out slightly after but had the traditions style bumpers. That sea of light sockets is screaming for a PCB holding sockets instead. Its funny how the pinball manufactures thought.
You're currently viewing posts by Pinsider bjm-maxx.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/another-ebd-screaming-for-attention-g94?tu=bjm-maxx and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.