Have a tech question.

The servo on the drop targets died. I replaced it and the new one is working. However when I run tests to move the drop target bank up or down it seems to move it halfway. I tested it with the playfield up so I could see what the servo was doing and the screw mechanism that hangs from the servo and runs through the little black trough under the drop target bank is moving a full range of motion from one side to the other but not completely raising or lowering the drop targets. Any ideas?

Thanks,
Chris

Thanks Ben - that worked. Now I just need to figure out why the ghost magnet seems to have stopped working.

I believe they print these on demand because I had to order a replacement a couple years back.