Anyone add a bill acceptor to Houdini? Suggested make and model?
Also: Is there a PF protector for this game? The usual sites don’t seem to have one.
Quoted from vireland:
You will have to tip the coin tray to close the door every time. The floor of the pin is too high by a smidge, so the door doesn't close with a bill acceptor installed unless you do.
Mars/MEI 2000 series 115v one works fine. Something like the AE2411. If you only care about $1, you should be able to get one used for less than $100. The harness adapter is $15 if they don't include it.
I’ve been having a weird tilt bob issue — it works just fine then, in play and test, it goes completely dead. And then, after a reset, works again for a bit. I’m mystified. Any ideas?
Update: I just can’t get the tilt working in gameplay after thorough scrubbing with alcohol and connection checks. It works great in test mode now, but the game will not tilt out. It’s at a competitive location so I need to get this sorted — I’ll grab the log or whatever and open a ticket.
YEAH!!! Looking forward to finally TILTING! This is a mega update, really excited.
My theater door wasn’t opening — I forced it open while in test mode a few times and got it running again. Anyone experience this? Seems like a broken motor is in my future :/
Great to see you're enjoying Pinside! Did you know Pinside is able to run thanks to donations from our visitors? Please donate to Pinside, support the site and get anext to your username to show for it! Donate to Pinside