My trunk shot went from being perfect to consistently going to far to the left. Power is perfect but direction is off. I can't see any possibility to adjust for direction?
You're currently viewing posts by Pinsider BioBa.
Click here to go back to viewing the entire thread.
My trunk shot went from being perfect to consistently going to far to the left. Power is perfect but direction is off. I can't see any possibility to adjust for direction?
Quoted from tatapolus:Same here, but it's going to the right.
Let's hope someone knows what to do.
Quoted from pinballinreno:Much has been said about it in this thread.
Do you have the upgraded power supply?
I would get that first. Then adjust the mech by adjusting the power or tilting it with washers or slotting out the mounting holes to allow for sideways adjustments.
I'm in Australia so not power supply issues (240V).
Consistent shooting to the left outside the trunk. I will try the washers. Thanks for the tip!
My flipper coils are very hot after 20 min play. Much hotter than any of my other machines. Almost uncomfortable to touch. Flipper strength is as recommended. Flippers work fine but do seem to get slightly weaker after playing for a while. Has anybody else touched their flipper coils? Is this normal with Houdini?
Quoted from LTG:Doesn't sound normal. I'd be sure your flippers have a tiny bit of up and down play ( not back and forth ) to be sure the pawl isn't binding on the nylon bushing below the playfield the flipper shaft rides in.
If that is good, then I'd remove the plunger assembly and be sure the plunger/plastic link/pawl moves freely.
LTG : )
Thanks. Checked all those things. No issue there. Could it be that not having an EOS switch the holding current is too high making the coil gay too hot?
Quoted from pinballinreno:Have you installed the upgraded power supply?
It should fix this.
Can you explain why?
Forgot to say I'm in Australia at 240V we don't need the upgraded power supply (I was told).
You're currently viewing posts by Pinsider BioBa.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/american-pinball-houdini-thread?tu=BioBa and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.