Hello all . My email is [email protected]
It seems the new 1.4 code link is not working . Does anyone have the code they can send? Im on v 1.02 and see that 1.04 would fix a lot of my issues. Thanks if you can help

Thank you for the code 1.4!
Before i update i had a question and the main reason i am updating is that im running version 1.02 . On my machime which is a mid production build # 75 about my service menu does not have an option for coils. Their is no coils section for adjustments. I am
Thinking this is because i have version 1.02 code.
Is anyone able to verify that for me ?
Does 1.02 lack the coils option in the menu for others or is their some other reason why mine does not give me this option ?
Thank you for any help or advice you can offer.

Averell
Thank you for the reply. My machine also has way to much power to the coils and thats my main reason for wanting to update as i do not have the option in my service menu for coil adjustments but i have seen code version 1.03 on a friends machine and he has the option for coil adjustments in his menu screen so i am assuming that the code update will make that possible. Thats why i was asking if anyone else that ran code 1.02 noticed their was no menu option for coils or could it be another issue with just my machine.
I am going to attempt update but really have no idea how to do so i will learn as i go !

ok i found why i have no coils menu and its that i am running 1.02 code which is basically the original code so can i skip 1.2 and go straight to 1.3 or 1.4 update ?

I found a post on this topic that i pasted below. apparently i will need to find the code 1.2 and update first before i install code 1.3 or 1.4 if the post below is correct. If so does anyone have code 1.2 i can get? my email is [email protected] . thanks in advance for any information as im just learning my way around this machine. Its a challenge but i absolutely love this game.

the post i found
Quoted from Mik-ReadingUK:
The reinstall went ok and I immediately upped it to 1.3 from 1.02 (presume that's safe to do!)

The Update from 1.02 to 1.2 is not only replacing the game code (files "pinprog" and "vidprog") as the 1.3 update does, but also adds/replaces more than 100 audio files, a video and some more files. The V1.2 update also includes the V0.8 and V0.9 firmware together with the firmware setup SW "avrdude".

Long explanation short: Do not skip 1.2.

Hello all
Im not sure im putting the usb into the right spot on the cpu to do my update. All 4 ports had something plugged in on bottom edge of board. On right side you will see i plugged a usb stick in . My update did not take it started and ended almost immediately and acted as it worked then rebooted and came up same software version 1.02. Could someone look at the picture below and advise if i had it plugged in at the right place ? Thanks for any help.

3CA6F6E8-DEFE-4BEA-AF05-613E7EC891FA (resized).jpeg

657692C7-DF89-4A0B-9FDF-4414396FA401 (resized).jpeg

73357730-172E-4732-8B6D-E12919BE87C9 (resized).jpeg

B4908F20-0979-488D-BEA1-2ED5E667A75F (resized).jpeg