Go into switch test and roll the ball over the orbit switches on the right side and check for consistency. You may need to adjust the switch arms and the switch base for alignment with ball.
(Topic ID: 154027)
You're currently viewing posts by Pinsider pincredible.
Click here to go back to viewing the entire thread.
Yes. There are 2 switches on each orbit that let the cpu know to trigger the coil for the gate.
This is the tweaking part.
Sometimes the switch is intermittent and needs replacing. Sometimes it's the actuator arms that need to be fiddled with for optimal performance.
Hold the ball against the ball guide and see where the wire contacts the ball. Should be on the very bottom of the sphere.
Promoted items from Pinside Marketplace and Pinside Shops!
Cincinnati, OH
You're currently viewing posts by Pinsider pincredible.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
